Newport-brass 16-30 Manual de usuario descargar pdf

2001 CARNEGIE AVE

SANTA ANA, CA 92705

www.newportbrass.com

Reserve Tissue Holder

Installation Instructions

Model No. 10-30, 12-30, 13-30, 15-30, 16-30, 17-30, 19-30, 22-30, 23-

30, 24-30

Recommended Installation by a Professional Contractor

1. Drill hole in wall at desired location using the appropriate drill size:

· Wood Screw (#6 x 2”) - use: 3/32" Drill

· Toggle Screw (6-32 x 3”) - use: 3/8" Drill

2. Fasten BASE (1) to wall using either WOOD/TOGGLE SCREWS (2). (See Fig. 1)

(Model 26-13, with Square BASE (1) configuration, (not shown) to be level.)

3.Thread ADAPTER (3) onto BASE (1). Position SPLINE (4), per the Table below, at the proper height from mounting surface. Secure into

place by tightening SETSCREW (5). (See Fig. 2)

4.Temporarily place POST (6) onto BASE (1) to check alignment. If necessary, loosen lower screw on BASE (1) and adjust. Retighten screw.

5.When applicable to model, locate the ESCUTCHEON and or DECORATIVE RING (7) over BASE (1), otherwise - Place POST (6) over

SPLINE (4) and against the ESCUTCHEON (7) or BASE (1). Secure into place by tightening the SETSCREW (5). (See Fig. 3)

5a.When applicable to model, insert the ESCUTCHEON NUT (8) into top of ESCUTCHEON (7). (See Fig. 3a) Assemble and secure with

additional items per Fig. 3.

5b. In addition to an ESCUTCHEON NUT (8), CRYSTAL ESCUTCHEON (7) also contains an ESCUTCHEON SHROUD (9). (See Fig. 3b)

Assemble and secure with additional items per Fig. 3.

Post Height

See Table

Fig. 1

Fig. 2

Fig. 3

(949)417-5207

AMS-10-30 Santa Ana CA 92705 1/15/04

www.brasstech.com

MODEL 10-, 15- 23- 12-

13-, 16-, 17-,

19-

24- 22-

POST HT. 2 5/16" 2 9/16" 2 3/8" 2 1/8" 2 1/16" 2 3/16"

Fig. 3a

Fig. 3b

1 2

Sin comentarios

Newport-brass 16-30 Manual de usuario